Torqueing the Bolts on the Curt Hitch C23FR on a 2021 Ford Escape
Updated 01/05/2026 | Published 09/10/2024
Question:
When I was torquing my hitch, I think it shifted a bit to where its slightly off center on the frame bolts on one side are not in the center of the hitch holes. Should I loosen it to readjust or do you think it be fine as is?
asked by: Nate
0
Expert Reply:
Hey Nate! If you already have your Curt Hitch item # C23FR installed then just leave the bolts torqued down. If you only had one side on I would say back them out but you're good.
expert reply by:
Jerred H
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Availability Of Trailer Hitch For 2026 Nissan Leaf
- Q&A: Will The Curt Hitch C67MJ Fit A 2025 Ford Escape PHEV Without Needing To Drill Into The Frame?
- Q&A: Do Curt Single Hook Coiled Safety Cables Meet Legal Requirements for Towing
- Q&A: Trailer Hitch And Wiring For A 2025 Ford Escape Hybrid
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Trailer Hitch and Wiring for a 2023 Ford Escape Hybrid
- Q&A: Will The Curt Hitch C23FR Fit A 2022 Ford Escape Hybrid?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Trailer Wiring Diagrams
- Article: How to Replace or Install an RV Roof Vent
- Article: Can You Flat Tow a 2025 GMC Yukon?
- Article: What Is Flat Towing and How to Ditch the Trailer
Jerred H.
1/5/2026
Hey Nate, how did things turn out with your Curt hitch after you torqued it down? Did it stay lined up well once everything was tightened? Your update could make it easier for the next person working through the same step.