What Are The Functions Of The Wires On The Dexter Brake Assembly 23-468
Updated 01/12/2026 | Published 08/28/2024
Question:
2008 Franklin dual axel 19 ft 6 replaced backing plate when hooking wires does it matter what wire you hook into
asked by: Ron
0
Expert Reply:
Hello Ron; no, it does not matter what wires are connected to what when installing new backing plates like the Dexter Nev-R-Adjust Electric Trailer Brake Assembly # 23-468. As long as one wire is connected to power and another is run to ground you will be good to go. It does not matter which is which.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Dexter Nev-R-Adjust Electric Trailer Brake Assembly - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Self Adjust
- 10 x 2-1/4 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: Is Drilling Required For Installation Of Roadmaster Front Anti-Sway Bar on 2026 Jayco Melbourne 24L
- Q&A: Replacement Parts For Lippert 7,000LB Trailer Axle On Kaufman Trailer
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Q&A: Trailer Hitch for 1998 Ford E-450 Shuttle Bus Conversion
- Q&A: Replacement 2" Coupler for a Ram CT8003 Coupler
- Q&A: What is the Latch on the Demco Channel Tongue Trailer Coupler Made Of?
- Q&A: Replacement 072-099-00 Leaf Spring and a Broken Spring Hanger
- Article: Spring Towing Readiness Checklist
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
Jesse M.
1/12/2026
Hey Ron, how did things go after wiring the new backing plates on your Franklin trailer? Your update could make it easier for the next person replacing their brake assemblies.