Is There a Touchscreen Remote For Ground Control 3.0 Leveling on Grand Design Trailer
Updated 01/27/2026 | Published 08/16/2024
Products Featured in This Question
Question:
We have a 2018 Grand Design Reflection 303rls 5th wheel trailer built in the summer of 2017. The Ground Control 3.0 module has the numbers 304136 and 20239 on it. Is there a touchscreen remote that will work with this system?
asked by: Colleen E
0
Expert Reply:
Hey Colleen,
The number gave references the control module for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC358590, and there is a touchscreen remote that will work with that. What you'll need is the following part number:
- Touchscreen Remote # LC358601
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does etrailer Carry Andersen Ultimate Safety Chain Attachment
- Q&A: Ultra Fab Electric Landing Gear Replacement for 2006 Keystone Raptor 3319
- Q&A: Where are Circuit Breakers/Fuses Installed on Lippert Electric Stabilizer Jacks
- Q&A: Replacement Front Jack for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Can I Grease or Lube the Inside of My Lippert 3.0 landing Gear?
- Q&A: Replacement Front Jack for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Can 5,500 RPM Landing Gear Motor for Camper be Upgraded to Faster Setup
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: What is a Fifth-Wheel Camper
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
Nick S.
1/27/2026
Hey Colleen, how did things go with the touchscreen remote for your Ground Control 3.0 system? Did it connect smoothly with your module? Your update could make it easier for the next person with the same setup.