What Is The Thickness Of The Steel Used For Rear Hanger 721585
Updated 07/31/2024 | Published 07/28/2024
Question:
What is the thickness of the steel used in this hanger, 3/16” or 1/4”?
asked by: Frank P
0
Expert Reply:
Hello Frank. The # 721585 hanger you mentioned is made of 1/4" thick steel. The 1/4" thick steel is standard for hangers used with 2" wide slipper springs.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Rear Hanger for 2" Wide Slipper Springs - 5-1/16" Tall - 9/16" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Camper
- Car Hauler
- Utility Trailer
- Slipper Springs - 2 Inch
- 9/16 Inch Diameter
- 5-1/16 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- etrailer
more information >
Continue Researching
- Q&A: Do I Need Longer Shackle Straps to Install the MORryde ALLTREK 4000?
- Q&A: Replacement Brake Assemblies for AL-KO T-44 Axles
- Q&A: How Much of a Slipper Spring Should be Sticking Out Past the Rear Hanger
- Q&A: How to Determine Correct Equalizer Upgrade For Triple Axle Toy Hauler
- Q&A: How To Choose Correct MORryde Shackle Upgrade Kit
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer
- Q&A: 1/2 X 13 Threads Per Inch Vintage Trailer Wheel Bolts
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Maintenance Schedule
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Most Popular Wheel Bearings
Frank P.
7/31/2024
Awesome, just what I need! Thanks!!