Looking For Hub With 1-3/8" L68149 Inner Bearing And 1.25" LM67048 Outer Bearing
Updated 02/03/2026 | Published 07/16/2024
Products Featured in This Question
Question:
looking for new hubs older dextar axles, using inner bearing 1-3/8 68149 and outer bearing 1.25 67048
asked by: Barry E
0
Expert Reply:
Hello Barry, thanks for reaching out. We do offer one hub that uses the 1-3/8" # L68149 inner bearing and the 1.25" # LM67048 outer bearing. We have the Dexter Trailer Hub and Drum Assembly # 8-407-5UC3-EZ. This hub is made for a 4,400 lb axle and has the standard 6 on 5-1/2" bolt pattern. This is designed to work with the 10" brake assemblies such as part # AKEBRK-35-SA
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Bearing Kit, LM67048/25580 Bearings, GS-2125DL Seal
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing LM67048 and 25580
- Race 25520 and LM67010
- 5200 lbs Axle
- etrailer
more information >
Continue Researching
- Q&A: Bearing Replacements for Dexter 5,000 lb Trailer Axle
- Q&A: Recommended Replacement Wheel Bearings On An Airstream Trailer
- Q&A: Will the 6,000 lbs Dexter Nev-R-Adjust Electric Trailer Brakes Work on a 5,200 lbs Axle?
- Q&A: Can I Use the Active Controls ActiveStart Plug-In Soft Start to Plug into a 25-amp House Outlet?
- Article: Most Popular Wheel Bearings
- Q&A: How to Choose the Correct Vent Cover
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Bearings for Dexter 5,200 lb Axles
- Q&A: Trailer Hub Bearing Kit for 2019 Flagstaff Super Lite 26RLSW Dexter 3722505 Axle 4k
- Article: Trailer Wiring Diagrams
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Trailer Tire Sizing
Jesse M.
2/3/2026
Hey Barry, how did the Dexter hub and drum assembly work out for your older Dexter axles? Knowing how the fit turned out could help others trying to match those same bearing sizes.