Will 6-Lug etrailer Hub and Drum Assembly Fit on Timbren Axle-Less System
Updated 02/03/2026 | Published 07/12/2024
Products Featured in This Question
Question:
Hi I have A trailer with these axles Part Number: ASR2KHDS02 They currently have electric brakes and a bolt pattern of 5x4.5 I would like to change the drums so I can run the bolt pattern 6x5.5 Is this the correct part number to achieve that? Part Number: AKHD-655-35-K Thanks
asked by: David G
0
Expert Reply:
Thanks for reaching out again, David!
Yes, the Trailer Hub and Drum Assembly # AKHD-655-35-K will fit with the Timbren Axle-Less Trailer Suspension # ASR2KHDS02!
expert reply by:
Jon G
0
Product Page this Question was Asked From
Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 6 on 5-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub with Drum
- Pre-Greased
- Standard
- L68149 / L44649
- Standard Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 6 on 5-1/2 Inch
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: What is Difference Between Trailer Hubs # AKHD-655-35-K and # AKHD-655-35-EZ-k
- Q&A: Can I Add Electric Brakes To A 2023 Aluma 7712H Trailer With A 3,500 lb Axle?
- Q&A: Replacement Hub and Drum Assembly for Lippert 4,400 lb Axle
- Q&A: Replacement Hubs and Brake Assemblies for Lippert 4,400 lb Axle
- Q&A: Replacement 3500 lb Hub/Drum for TruRyde RVD-H-65535 10 Inch Trailer Brake Drum
- Q&A: Replacement Bearings, Races, Grease Seals & Brakes For Lippert 4,400LB Axle On Jayco Travel Trailer
- Q&A: Picking Out Trailer Brake Assemblies that Have Bolt Pattern 2-7/8 inch by 2-7/8 inch
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure a Trailer Axle
- Article: Trailer Lighting Requirements
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Article: How to Measure Your Trailer Wheel Bolt Pattern
Samuel C.
2/3/2026
Hey David, how did the new hub and drum assemblies work out with your Timbren axle setup? Your results could really help others looking to switch to the 6x5.5 bolt pattern too.