Where Do The Green Wires On The Dexter Trailer Brake Assembly Connect?
Updated 07/20/2024 | Published 07/06/2024
Question:
I have electric brakes each side has two green wires one for ground but what does the other green wire get wired to?
asked by: Mike
0
Expert Reply:
The other green wire from the Brake Assembly # 23-468 will go to the 7-way junction box and receive power from the trailer brake controller. The reason both wires are green is they power an elctromagnet which is not polarity specific so you only need to ensure the one side is grounded and the other is connected to the brake controller circuit.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Dexter Nev-R-Adjust Electric Trailer Brake Assembly - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Self Adjust
- 10 x 2-1/4 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: Is Drilling Required For Installation Of Roadmaster Front Anti-Sway Bar on 2026 Jayco Melbourne 24L
- Q&A: Replacement Parts For Lippert 7,000LB Trailer Axle On Kaufman Trailer
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Q&A: Trailer Hitch for 1998 Ford E-450 Shuttle Bus Conversion
- Q&A: Replacement 2" Coupler for a Ram CT8003 Coupler
- Q&A: What is the Latch on the Demco Channel Tongue Trailer Coupler Made Of?
- Q&A: Replacement 072-099-00 Leaf Spring and a Broken Spring Hanger
- Article: Spring Towing Readiness Checklist
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
Mike
7/20/2024
It’s not working. Is there a specific brake controller I need to use?