Does Installation of Bearing Buddy Require Removal of Zerk Fitting
Updated 02/03/2026 | Published 06/29/2024 >
Question:
My boat trailer has grease fittings installed on the spindles but I want to replace them with bearing buddies. Do I need to remove the original fittings?
asked by: Kevin
0
Expert Reply:
Hi Kevin; yes, you will need to remove the zerk fittings to install the Bearing Buddy Bearing Protectors # BB2240SS.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 2240SS - Stainless Steel - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 2.24 Inch
- 5200 lbs Axle
- Bearing Buddy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: 46304
- Shop: Kodiak 12" Rotor - 6 on 5-1/2 - Dacromet - 5,200 lbs to 6,000 lbs
- Search Results: surge brake master cylinder
- Search Results: accessories and parts
- Search Results: trailer brakes
- Search Results: brakes
- Search Results: trailer tires and wheels
- Video: Checking Out the Kodiak 12" Rotor
- Search Results: bearing buddies
- Shop: Replacement DeeMaxx Disc Brake Caliper - Maxx Coating - 3,500 lbs to 6,000 lbs
- Shop: DeeMaxx Ceramic Brake Pads with Stainless Steel Backing Plates - 3,500 lbs to 6,000 lbs
- Q&A: Will the Kodiak Disc Brake Caliper KDBC225DAC Replace the TDE 46304 Brake Calipers?
- Video: Set up: Kodiak Hydraulic Brake Line Kit on a 2018 Shasta Phoenix Fifth Wheel
- Video: Ultimate Overview of the Kodiak Hydraulic Brake Line Kit
- Shop: Kodiak Hydraulic Brake Line Kit - Tandem Axle - 20'
- Shop: Kodiak Hydraulic Brake Hose - FIF and 90-Degree Male Fittings w/ Stainless Flares - 1.5'
- Video: DeeMaxx 12" Rotor Review
- Shop: DeeMaxx 12" Rotor - 6 on 5-1/2 - Stainless Steel - 6,000 lbs
- Video: Bearing Buddy Bearing Protectors-BB2441SS Feature Review
- Video: Protect Your Bearings! Inside Look at Bearing Buddies with the Manufacturer
- Shop: DeeMaxx 10" Hub/Rotor Assembly - 5 on 4-1/2 - Maxx Coating - 3,500 lbs
- Video: Hands-On with the Replacement Bearing for etrailer and Ram Square Jacks
- Q&A: Greasing EZ Lube Spindles When Grease Comes Out Cotter Pin Hole
- Q&A: When Using Bearing Buddy Bearing Protectors Do I Need To Repack Bearings Periodically?
- Q&A: Do Grease Zerks Need to be Removed to Use Bearing Buddies
- Q&A: Comparing EZ-Lube Spindles to Bearing Buddy Grease Caps
- Q&A: Should You Remove Grease Zerk on EZ Lube Spindle to Install Bearing Buddy
- Q&A: Will Bearing Buddy Fit on Trailer Axle With EZ Lube Spindles



Robin H.
2/3/2026
Hey Kevin, how did the swap to the Bearing Buddy protectors go after removing the zerk fittings? Knowing how the fit turned out could help others looking to make the same change on their trailer.