Recommended Lift Kit for a 3" Diameter Suretrac Axle
Updated 02/03/2026 | Published 06/26/2024 >
Question:
I have purchased a new trailer that is just too darn low to the ground. This kit looks perfect, other than my axles are Suretrac 5200 W/Ebrake. I did measure them at 3. It sure looks like they would work, just dont have any real knowledge between Dexter and Suretrac. Thank you for your help. marc Attached is a picture of my Axle Tag
asked by: Marc G
Expert Reply:
Thanks for the picture Marc! So long as your Suretrac axle is 3" in diameter the Dexter Trailer Springs Over-Under Conversion Kit item # K71-385-00 will work just fine with it. This kit works by moving your axle below your springs and gives you a lift equivalent to your axles thickness, which in your case would be 3".
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Q&A: Lift Kit Solution to Allow Fifth Wheel Trailer to Sit More Level When Towed
- Q&A: What Upgraded Equalizer Can I Use to Replace My 5 5/8" Long Standard Equalizer?
- Q&A: Recommended Equalizer for a 2018 Coachmen Apex Ultralight
- Q&A: Axle Lift For A 2004 Coleman Pop-Up Camper
- Q&A: Lift Kit Needed For A Big Tex 14GX Tandem Axle Gooseneck Trailer
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: How to Lift a Gooseneck Trailer w/ Standard Axles
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Trailer Wiring Diagrams
- Article: Converting Your RV Water Heater to Tankless
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Double-Eye Trailer Suspension System Review



Jerred H.
2/3/2026
Hey Marc, how did the over-under conversion kit work out with your Suretrac axles? It sounds like the 3-inch diameter should have been a good match. Sharing how it turned out could help others with the same axle setup.