What Happens if Trailer Leaf Spring Shackle is Almost Flat
Updated 05/06/2024 | Published 05/05/2024 >
Question:
Hello, when I ordered my new leaf springs I measured the existing mounting holes but didnt account for any sag once the load was put on them. The shackles are pushed pretty far to the rear after the jack was lowered. Do you think this will be OK?
asked by: Tom L
Expert Reply:
Hey Tom, thanks for the picture. So the problem will be that when you hit a bump the spring will run out of room to flatten out so the suspension will essentially get very hard at that point and the trailer will bounce pretty hard. I would recommend going with a shorter length spring or moving your hangers out further.
Product Page this Question was Asked From
3-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 23-1/2" Long
- Trailer Leaf Springs
- Double Eye Springs
- 9/16 Inch Eye
- Nylon Bushings
- 2000 lbs
- 1-3/4 Inch Wide
- 3 Leaf
- 23-1/2 Inch Long
- Standard Grade
- Universal Group
more information >
Continue Researching
- Shop: RV Exterior Lighting
- Search Results: trailer leaf springs
- Shop: MORryde X-Factor Crossmember for Standard Frame Hangers
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Shop: LED Porch and Utility Light for RVs - Oval - Clear Lens
- Search Results: license plate light
- Search Results: trailer jack
- Search Results: carbon monoxide detector
- Search Results: self~leveling sealant rv roof repair
- Search Results: spare tire tool
- Search Results: propane detector
- Video: Review of MORryde Trailer Suspension Parts - MR85DR
- Video: Review of ESCO Trailer Breakaway Kit - ES34FR
- Shop: Trailer License Plate Light with Housing and Mounting Bracket - Clear Lens - Black Base
- Shop: Replacement Water Valve Kit for Thetford Aqua-Magic Style Plus and Style Lite Toilets
- Shop: ESCO Alarmed Breakaway Switch
- Shop: Replacement Breakaway Switch for Bright Way Trailer Breakaway Kits
- Q&A: Are the Wet Bolts in the MORryde Suspension Upgrade Kit a One Time Use
- Q&A: On Part # TSS-107-40 What Is The Minimum Dimension Between Frame and Top Of Spring Plate
- Q&A: Can Lock Nuts Be Reused on Trailer Suspension Bolts After Being Removed
- Q&A: Can 4,000 lb Axle Leaf Springs be Used on a 3,500 lb Axle for a
- Shop: Replacement Water Module Assembly for Thetford Aqua-Magic V and Aqua-Magic VI RV Toilets
- Q&A: Is it Ok to Replace Factory Leaf Springs With a Higher Capacity Option?
- Q&A: Is There A Hitch Extender For 2.5" Hitch With A 7,500lb GTW Capacity
- Q&A: Lookiing To Upgrade Axles On 2015 Keystone Cougar 33RBK
- Video: An In-Depth Look at the MORryde X-Factor Crossmember for Standard Frame Hangers
- Video: Detailed Breakdown of the Dexter Single Axle Heavy Duty Suspension Kit
- Video: etrailer Rust-Resistant 4-Leaf Double Eye Spring for 4K Trailer Axles Spec Review
- Video: All You Need to Know About the Dexter Trailer Springs Over-Under Conversion Kit
- Shop: Suspension Enhancement


