How To Remove Light Cover To Replace Screw

Question

Question:

I have this light as an exterior porch light. One side has pulled off, just need a slightly bigger screw. How can I take this apart without breaking it or damaging my trailer?

asked by: Tony B

0

Light On Trailer
(click to enlarge)

Expert Reply:

Inserting a flathead screwdriver in those cutouts and applying pressure should allow you to pop off the cover of the light. From there you will be able to see the mounting holes and replace the screw. If this is an Optronics Opti-Brite like # ILL70CBSBAWN the mounting hole diameter is 3/16".

expert reply by: Robin H

0

Answer 1

Hello again Mark, Great question. Since you’re working with the Opti-Brite LED Strip Light w/ Switch for RV Awnings - Weatherproof - Black Housing - 11" Long #ILL70CBSBAWN and need to fit everything back through that small hole, I’d avoid the…

view full answer...

Answer 2

There are many 12V LED lights which are available for the inside of a cargo trailer. The thing about LED lights, however, is that you are never going to have to pull a light out of the socket and replace it with a new one. For example, the Optronics…

view full answer...

Answer 3

If you grab light #ILL70CBSBAWN and hold the base with one hand you can pivot the light part up, almost like it is hinged. The gasket has an adhesive on it that makes it seem like the 2 parts are all one piece but they aren't. I tested this out…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 6

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 7

Hey Arkadius, welcome back! Yes, the ducted version of the Chill Cube comes with a remote. However, you're going to need the complete system for a replacement. You can choose from the following based on color: -Furrion Chill Cube RV Air…

view full answer...

How To Remove Light Cover To Replace Screw

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching