Troubleshooting Signal Loss On Furrion Vision S 7" Backup Monitoring System 2017 Ford F-150
Published 03/25/2024
Question:
I am having signal loss problems with my Furion s 7 back up camera system. Will the part #VGR64VR unit solve this problem on a 2017 Ford F150 ?
asked by: Floyd M
Expert Reply:
The 12V PWM Filter # VGR64VR is only required trailers which are being towed with a vehicle that uses Pulse Wave Modulation wiring. The most common being the 2021 and newer GM trucks. This was not a wiring type used on your 2017 Ford F-150. I would start by checking the 7-way connector for any damage on both your truck and the trailer. You may have some corrosion built up on the terminals which is causing power to degrade going to the camera and running lights on the trailer. Next I would remove the camera and check its connector. be sure to check as much as the wiring as possible going to the camera as well as it may have rubbed and developed a short.
You can also take the rear camera completely off and connect it directly to the harness in your truck which will allow you to bounce the camera around and determine if there may be an internal short inside the camera which is causing the issue. If you are still having issues please let me know and I can reach out to Furrion with any additional input or tests they recommend.
Product Page this Question was Asked From
12V PWM Filter for RV Backup Camera Systems - Hardwire
- Accessories and Parts
- Backup Camera
- RV Camera System
- Cables and Cords
- Power Line Filter
- Voyager
more information >
Continue Researching
- Shop: 12V PWM Filter for RV Backup Camera Systems - Hardwire
- Video: How to Set Up Your 12V PWM Filter for RV Backup Camera Systems on a 2020 Taxa Mantis Travel Trailer
- Q&A: No Signal on Furrion Vision S Wireless RV Backup Camera System
- Shop: Voyager PWM Filter for Voyager RV Camera Systems - CEC Connector
- Q&A: No Signal And PWM Fix For Furrion Vision S Camera System Connected To 2022 GMC
- Q&A: Furrion Camera Has Power but Won't Pair
- Q&A: Troubleshooting A Furrion Vision S RV Camera System That Fades In And Out Of Pairing
- Q&A: Can I Use One of the 12V PWM Filters for a Four RV Backup Camera System?
- Q&A: Power Adapter For Pulse Width Modulation On 2022 Chevrolet Silverado 2500 To Use Furrion Cameras
- Q&A: Does 2025 Chevy Silverado 2500HD Require Power Adapter for Install of Furrion Vision S+ System
- Article: Trailer Wiring Diagrams
- Article: How to Mount a Truck Bed Camper
- Article: Holiday 2025 | Best Gifts for RVing
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
Floyd
3/25/2024
Thank you for the info. I have changed my monitor back to the original 4.5:" monitor and the whole thing works just fine. It only looses signal, and that intermittently ,when I use the 7" monitor. The smaller monitor is just too hard to see objects behind me as I travel. That is why I tried the 7" monitor. Thanks again for your help, Floyd.