Can 12k Axle Be Converted from Electric Over Hydraulic to Electric

Question

Question:

Can you replace electric over hydraulic with straight electric brakes. It has 12k axles but I do not know the brand axle it’s on a southwest trailer.

asked by: Levi

0

Expert Reply:

Yes it definitely is possible to replace the electric over hydraulic brake setup on your trailer with electric brakes. The 12k axles are a little more particular than the lower capacity axles so you will need to know what brand axles you have. As long as they are Dexter or Lippert you can use the brake assembly set part # # AKEBRK-12 to replace the assemblies you have now. These will fit in the same drums your axle has currently.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

Hey Kathryn, what specifically on the Blue Ox Alpha are you needing to replace? Unlike Roadmaster they don't have as many replacement parts but you can contact them about getting yours rebuilt but that's just not something we can help with.…

view full answer...

Answer 8

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 9

Hey JT! Sorry to hear about your trouble with the leaf springs. Hopefully there wasn't a lot of damage and everyone stayed safe. From what I have found the 26E-3500 is the same as the Dexter 072-027-00. This is the 6-Leaf Double-Eye Spring for…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Can 12k Axle Be Converted from Electric Over Hydraulic to Electric

Product Page this Question was Asked From

Continue Researching