Recommended 3 to 2 wire Converter for Adding in a LED Third High Brake Light

Updated 03/14/2024 | Published 03/05/2024

Products Featured in This Question

Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2

(42)

$9.48

Question:

My RV has 2 wire combined brake and turn signal LED lights and I want to add a center high mounted brake light, also LED. I understand this Curt 2 wire to 3 wire converter is not compatible with LEDs. Can you recommend a product that might work? Thank you.

asked by: Pete A

Expert Reply:

Hey Pete, so to add a third brake light that uses two wires to your 3 wire system you're going to need to use # 118158 to splice into your combined right/stop and left/stop wiring, then connect your 3rd LED brake light to the stop output on the converter.

If there ends up being some hyper flashing you'll need to add in the Load Resistor Kit for LED Turn Signals # DI34ZR between the converter and the light, which will create a stronger draw like incandescent lights.

expert reply by: Bryce D