Parts Needed To Add 7-Way Plug To A 2011 Range Rover HSE Sport
Updated 03/04/2024 | Published 03/02/2024 >
Products Featured in This Question
Question:
Hi, I am looking for a 7 pin wiring kit for my 2011 Range Rover HSE Sport. The vehicle already has the factory tow hitch as an fyi, along with the mounting holes for the socket. I wasn’t sure which kit to get. Thanks in advance Mark
asked by: Mark H
Expert Reply:
Hey Mark, I can definitely help set up your 2011 Land Rover Range Rover HSE Sport with a 7-way plug. It sounds like you do not have any trailer wiring currently, so you will need the following wiring kits:
Curt Powered Tail Light Converter # C59236
Universal Installation Kit # ETBC7
These two kits will include everything needed to install a 7-way, including all of the necessary wires for an electric trailer brake controller. For that I recommend the Tekonsha Prodigy P3 # 90195, since it is our most user friendly, and reliable brake controller.
I have linked a few of our install and review videos for these products below if you want to take a look.
Product Page this Question was Asked From
Stabilizer Jack - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 1
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 0 - 1000 lbs
- Manual Jack
- Bolt-On
- Weld-On
- 1 Jack
- etrailer
more information >
Featured Help Information
Miscellaneous Media





Continue Researching
- Q&A: How Thick of a Panel Will Fit Into # PF38FR?
- Q&A: Do K-Source Tow Mirrors # KS48NQ Fit 2026 Toyota Tundra TRD
- Q&A: Recommended Voyager WiSight Camera for a New Trailer Without Pre-Wire
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Recommended Stabilizers For Ramp Door On Toyhauler
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Installation Method for the Pro Series Coupler part # PSE338050303
- Q&A: Can Weld-On A-Frame Trailer Coupler be Replaced with a Bolt-On Coupler
- Q&A: Can Demco Coupler # DM14793-52 Have Holes Drilled for Installing Coupler
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)

