Where Are Trailer Hitches For 2013 GMC Acadia Made
Updated 04/22/2014 | Published 04/20/2014
Products Featured in This Question
Question:
Where is the hitch made.
asked by: Danny N
Expert Reply:
We have a few trailer hitches that will fit your 2013 GMC Acadia. The Curt Trailer Hitch, part # 13424, is made in the USA, and is a Class lll hitch with a 2 in by 2 in receiver opening. This hitch is an easy, bolt-on installation.
Another hitch we carry is the Draw-Tite Trailer Hitch, part # 75528 that is a fit for your Acadia. It is also made in Mexico and is a Class lll hitch with a 2 inch receiver.
If you are planning on towing, I recommend the etrailer.com Ball Mount Kit, part # 989900. It comes with ball mount part # C45010 and ball mount part # 2753. along with a 1-7/8 inch diameter ball, part # 19260, and a 2 inch diameter ball, part # 63845. It also includes a hitch pin and clip part # PC3, and a bag to store the parts in, part # ETBMB. You can also find all of these parts separately. I have attached a link to our Ball Mount helpful article for you to check out.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What to do if Bolts Seem Too Large to Install Hitch on 2017 Buick Enclave
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Timbren Silent Ride Suspension for 2023 Grand Design Solitude 390RK
- Q&A: What Does etrailer Trailer Hitch e36AR Fit
- Q&A: Does the Kuat NV 2.0 Work with Bikes with Fenders?
- Q&A: How to Replace Tie Down Engineering LP7000 Actuator
- Article: Determining Trailer Tongue Weight
- Q&A: Can Bike Rack be Used in Front Hitch of Truck
- Q&A: Dirt Bike Carrier With Car Tow Dolly on Class C Motorhome
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)