Does RV Mesh Pocket OBE64FR Have Weight Capacity

Question

Question:

How many pounds will this carry without popping loose from the snaps?

asked by: Linden G

0

Expert Reply:

The RV Mesh Pocket part # OBE64FR that you referenced does not have a weight capacity listed or a weight that it would come off the snaps so you'd have to use your best judgment. Most common things you'd put in a pocket like this wouldn't be an issue though.

expert reply by: Jameson C

0

Answer 1

Hey Steve, great question! The magnets on the BTBRV Magnetic Hitch Receiver Reducer Sleeve #BTBRV64FR are strong enough to keep this from happening. They will keep it secure in your 2-1/2" receiver so you don't have to worry about it sliding…

view full answer...

Answer 2

The magnet itself is 3 3/8" wide and the piece that it is on is 4" wide, so you'll need at least 4" of room to mount the Thule Telescoping Ladder for Van #TH301404 on your 2013 Sprinter.

view full answer...

Answer 3

I checked the instrucions for the Thule Elite Van XT 2 Bike Rack #TH302013 which states you should use one of the following adhesives: Dekalin MS 5, SIKA 252 or Terostat MS937. I looked up the strength of the Manus Bond 75-AM adhesive and it may work…

view full answer...

Answer 4

For your 2017 Winnebago Travato 59 K I recommend the Malone DownLoader Kayak Carrier and TelosXL Load Assist w/ Tie-Downs #MPG114MD-351XL as a convenient option to load your kayak onto the roof rack. The Telos Load Assist can extend over 8 feet in…

view full answer...

Answer 5

The Camco Pop-A-Plate Disposable Plate Dispenser #CAM57001 will work fine with standard uncoated paper plates (the type that often need to be doubled-up for sturdiness) and it also works with disposable plastic plates. A heavier quality coated (or…

view full answer...

Answer 6

Hello Cynthia, I wasn’t seeing just the grill listed on our site either, so I reached out to our friends at B and B Molders to see if I could get it added. My contact let me know that the grill is only sold in a 250-pack, and the per-unit cost…

view full answer...

Answer 7

Hello Rob, According to my research, the Invision Microwave part number #2057374 is an OEM part number, which makes finding public information a little more difficult. From what I was able to find, your microwave should be approximately: Width: 23.45…

view full answer...

Answer 8

The part #LC25ED is correct for you. Just the wiper portion is 1-1/4 inches wide like you need and entire width is 2 inches.

view full answer...

Does RV Mesh Pocket OBE64FR Have Weight Capacity

Product Page this Question was Asked From

Continue Researching