Is Special Mounting Hardware Required to Install License Plate Light # LP51CB
Published 04/17/2014
Products Featured in This Question
Question:
Does LP51CB trailer license plate light require LP52HP for mounting?
asked by: Kevin O
0
Product Page this Question was Asked From
Optronics Trailer License Plate Light - Incandescent - Gray Housing - Clear Lens
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 1-3/4W Inch
- White
- Optronics
more information >
Continue Researching
- Q&A: What Comes With The etrailer Swivel Jack w/ Bolt-On Mounting Plate # e54RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Is There An Upgrade For a Ventline E-Z Ventadome Trailer Roof Vent?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How Far Apart Are The Holes On The Demco Coupler DM15945 And What Size Bolts To Use
- Q&A: Trailer Jack to Avoid Tailgate Clearance Issues
- Q&A: What is the Hole Spacing for etrailer Square Jack w/Drop Leg - Bolt On - Sidewind - 2.5K MJSQ-2500B
- Q&A: Replacement Rubber Plug for EZ Lube Spindles
- Q&A: Diagram for Replacing Titan Model 10 Actuator Shocks
- Article: Trailer Lighting Requirements
- Article: Best Bike Racks for Electric Bikes
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Measure for Trailer Hitch Drop