What Should The Ohm Reading Be For 10" Electric Brake Assemblies
Published 12/19/2023
Products Featured in This Question
Question:
FOR 10 INCH BRAKES WHAT SHOULD THE OHM READING AT THE TRAILER PLUG BE FOR A DUAL AXLE TRAILER
asked by: SCOTT H
0
Expert Reply:
For a 10" brake assembly like the # AKEBRK-35-SA you should be reading 3.0-3.8 ohms.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Brake Controller Installation: Starting from Scratch
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can I Use a 4 Way Vehicle Connector with 7 Way Adapter and the Curt Echo Brake Controller?
- Q&A: Troubleshooting Blown Vehicle Fuses Every Time Trailer is Connected
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer