What Tool to Use for Enlarging 1-7/8 inch Trailer Jack Hole to 2 inch
Published 11/02/2023 >
Question:
I need to increase the hole diameter in trailer tongue from 1 7/8 to 2 for new trailer jack. Any advice on the best way to enlarge the jole size.
asked by: Leslie E
0
Expert Reply:
When we have to enlarge holes here for the install of trailer hitches we usually use a rotabroach tool but the best tool to use is a reamer. Since you're making a relatively small size increase I would find a 2 inch reamer tool for a power drill and go with that.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Loadstar ST175/80D13 Bias Trailer Tire with 13" Galvanized Wheel - 5 on 4-1/2 - Load Range D
- Trailer Tires and Wheels
- Tire with Wheel
- Bias Ply Tire
- Load Range D
- 175/80-13
- 13 Inch
- M - 81 mph
- 5 on 4-1/2 Inch
- Steel Wheels - Galvanized
- Kenda
more information >
Continue Researching
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Q&A: Replacement Disc Brakes for Trailer With Dexter Disc Brakes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Difference Between a ST175/80D13 and a ST175/80R13 Trailer Tire
- Q&A: Total Height of Round, Pipe Mount Swivel Jack # TJP-5001S-B
- Q&A: Choosing Between Kenda Karrier and Kenda Loadstar ST175/80-13 Tire
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Q&A: Standard Color Code for Wiring Simple 4 Wire Trailer Lighting
- Q&A: Alternative for Fulton F2 Winch On Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Determining Trailer Tongue Weight

