2017 Winnebago Winnie Drop Travel Trailer Replacement Fender Recommendation

Question

Question:

Looking for a Fender to fit My 2017 Winnebago Winnie Travel Trailer. Tire Size: ST205/75R14 Width Between Bottom Edges: 30 6/16 Depth out from Trailer: 10 2/16

asked by: James M

0

Expert Reply:

The closest fender we have to the specs you sent in is the Single Axle Trailer Fender for Enclosed Trailer for 13" to 15" Wheels # HP66FR which measures 36" long x 10-3/4" wide x 20" tall and installs using the Mounting Brackets # CE26098G-2. It's a little larger than what you currently have but will fit with your tires just fine.

expert reply by: Jon G

0

Answer 1

Hi Dave, welcome back! That does sound like the standard 14" x 14" opening, maybe just a tad off. I'm sure your old vent was designed for the same opening size so you won't have any issues adding in a new vent like the MaxxAir…

view full answer...

Answer 2

The Dexter 10" Hub-and-Rotor Assembly part #K08-435-05 works with the Grease Cap part #F001518.

view full answer...

Answer 3

Using the cut off wiring harness you have for the P3 part #90195 you will wire it to the brake controller wiring of your 2023 Ford Ranger which is sticking out of the large wire harness that goes through the driver's side firewall, left of the…

view full answer...

Answer 4

The length of a fender is measured from the longest point, at the very bottom of each end across. Then the height is measured from the tallest point, right in the center. For example, the CE Smith Single Axle Trailer Fender #CE17720 is 22-1/2"…

view full answer...

Answer 5

Your best route is to replace your entire surge brake assembly as Atwood no longer produces any parts for their brake actuators. The Titan Zinc-Plated Brake Actuator #T47457207K is going to be your best replacement available. It is specific to disc…

view full answer...

Answer 6

Part 300-020885 refers to an EZ Loader boat trailer BT150/B151 bearing kit. Part #300-020883 refers to a complete 5-on-4-1/2 idler hub kit that includes races, bearings, seal, washers, nut, retainer nut and cotter pin, bearing protector and lug nuts.…

view full answer...

Answer 7

I am sorry Mike but we do not sell custom fit fenders for your Forest River R-Pod. The absolute closest thing I could offer would be the CE Smith Single Axle Trailer Fender item #CE17100ATB. It measures 10" Wide x 32" long x 16" tall…

view full answer...

Answer 8

It does look like the Coleman Mach 3 Plus Air Conditioner 48203C969 is still an AC unit that is in production but I recommend going with the 13.5K Btu Advent Air RV Air Conditioner #ACM135B and Coleman Mach Adapter Wiring Kit #ACCOLKIT instead for…

view full answer...

Answer 9

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 10

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 11

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 12

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

2017 Winnebago Winnie Drop Travel Trailer Replacement Fender Recommendation

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching