Replacement Manual Override Grommet For A Solera RV Awning Drive Head

Question

Question:

Is it possible to buy just the rubber access hole plug?

asked by: Rick

0

Expert Reply:

Yes, you'll just need part # LC95ED to replace your lost or damage manual override grommet on your Solera RV Awning drive head cover.

expert reply by: Kevin C

0

Answer 1

You do not need to replace your Fastway e2 Weight Distribution #FA92-00-0800. As you suspected, a new shank is all it will take to get you going again. Fastway doesn't have one for a 2-1/2" receiver, but Equal-i-zer who makes Fastway does.…

view full answer...

Answer 2

Hi Jake! The back cover for the Replacement Front Cover for Lippert Edge Awnings - Idler Head - Black #LC37UD will be the #LC73UD. Just in case you also needed the drive head, the front cover for that will be #LC32NJ and the rear cover is the…

view full answer...

Answer 3

Below is a list of the head cover components for your 58" Lippert Edge Support Arm Assemblies 806623 Replacement Lippert Edge Awning Drive Head Back Cover #LC43UD Replacement Lippert Edge Awning Drive Head Front Cover #LC32NJ Replacement Lippert…

view full answer...

Answer 4

Hey Michael! Sorry to hear about your missing connector. After Hopkins shut down our Brake Buddy parts ran out quickly, and we no longer have replacement parts available. It looks like you already figured this out, but the best solution is to get a…

view full answer...

Answer 5

Hey James, the sitting dimension width of the Thomas Payne Trifold RV Loveseat and Sleeper #LC44FC that you referenced is 72 inches wide and yes it would fit through a 28 inch wide door. The trick is to assemble the couch inside the RV once all of…

view full answer...

Answer 6

Hey, Daniel. Thanks for your question. We do have a weight distribution hitch that would work for your trailer and still use chains. That hitch is the Blue Ox SwayPro #BXW0350. The tongue weight rating needed for this system to work is between…

view full answer...

Answer 7

I have a few options to replace the iRV33 Stereo. The iRV RV Stereo part #292-101079 you mentioned would require you to enlarge the cutout as well as hardwire the wiring harness which is pretty common for stereo installations. If you are looking for…

view full answer...

Answer 8

Hey Mark, yes we do have a version of the Andersen part #AN88VR with a 2-5/16 inch ball instead with the part #AN53VR. What does your trailer weigh?

view full answer...

Answer 9

Hey Delbert, thanks for reaching out! Yes, the Andersen Weight Distribution Hitch w Sway Control #AN53VR can be used for a lighter trailer like what you have. You'll just need to adjust the system to accommodate your weight and you'll be good…

view full answer...

Answer 10

The correct manual override cover for your 3,500lb electric Ram jack is the Replacement Manual Override Cap for etrailer A-Frame Electric Jack #EJ-3520-BCP. For a cover you can use the Ultra-Fab Protective Cover for Electric A-Frame Jacks…

view full answer...

Answer 11

If the light on your Ram Electric Jack w/ Footplate #EJ-3520-BBX is working but the jack motor is not actually getting any or enough power to operate, I first recommend checking to make sure the power source is good. Make sure the battery you are…

view full answer...

Replacement Manual Override Grommet For A Solera RV Awning Drive Head

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching