Lights Needed for 102" Wide x 25' Long Trailer

Question

Question:

I am designing a 102 inch wide 25 foot long box trailer. Can I use the TecNiq Mini LED Trailer Fender Clearance Light # TN78XR even though this is not a boat trailer? If so, would I need to mount one on each corner or can I just put one on each side in the middle. the trailer does not have fenders. The wheels are located inboard of the outer edge of the box so the widest point extends the full length of the box. Thanks

asked by: Dave

0

Expert Reply:

The TecNiq Mini LED Trailer Fender Clearance Light # TN78XR can be used even though this isn't a boat trailer, and these can be installed on the sides of your trailer - you don't have to install these only on the fenders.

For a complete light setup you need the following:

- Optronics Trailer Light Kit for Trailers over 80" Wide # TL16RK
- LED Identification Light Bar for Trailers over 80" Wide # MCL93RB

I'm also attaching a link to our helpful article on trailer lights for you to check out.

expert reply by: Jon G

0

Answer 1

The Valterra No-Fuss Flush #A70 and HydroFlush #VAL42RB have the same application, and one is not more powerful than the other. They have the same spray pattern and the holes are not a different size. The difference is really just what you mentioned,…

view full answer...

Answer 2

Hey Steve, for trailer applications a dual stage regulator will work best. The big difference is a single stage regulator is best in situations where the inlet pressure does not vary by much. Since you'll most likely have higher pressures when…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Lights Needed for 102" Wide x 25' Long Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching