Troubleshooting A Furrion RV Camera System That Won't Stay Connected To The Monitor

Updated 08/25/2023 | Published 08/24/2023

Products Featured in This Question

Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 5" Screen

(735)

$393.95

12V PWM Filter for RV Backup Camera Systems - Hardwire

(235)

$70.29

Question:

Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 5inch Screen Item #FOS05TASF Had this item not quite a year. Very little use. Worked well for awhile. Now it will not stay connected. Says no signal. Will occasionally turn on very briefly but then picture freezes and it turns off. We tried pairing it again and it doesnt help. Really frustrating. Can someone assist?

asked by: Paula C

Expert Reply:

The number one cause of issues with a Furrion Vision S Wireless RV Backup Camera System w/ Night Vision # FOS05TASF always comes down to power. Depending on the vehicle you're towing the trailer with you could have PWM wiring and be sending just enough power for the camera to turn on but not enough for it to actually operate. The easiest way to solve this issue is to install the 12V PWM Filter # VGR64VR, which will store power and provide a steady 12v stream to the camera.

To install this filter you'll have to remove the camera from the mount and splice into the wiring behind the camera. I've attached a short video below where I'll walk you through the process.

expert reply by: Kevin C