Does The Polar Vent for Enclosed Trailers Have An Interior Mounting Piece
Updated 06/29/2023 | Published 06/28/2023
Products Featured in This Question
Question:
Is there an inside component to this vent or only an outside piece?
asked by: Brian S
0
Expert Reply:
The Vent for Enclosed Trailers # PLR20 would only mount on the outside of the trailer and would not have a piece to go inside of the trailer. I recommend using some butyl tape # AL28FJ on the mounting flange and non-sag sealant # 344270341437-1 around the outer edge for a waterproof seal.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Exterior Wall Vent for Enclosed Trailers - Aluminum - 12-1/4" x 10-1/2"
- RV Vents and Fans
- Vent
- Wall Vent
- No Fan
- Metal
- Silver
- Polar Hardware
more information >
Continue Researching
- Q&A: Will the Draw-Tite Ball Mount # 2923 Work on a 2024 Tesla Model Y with the Tow Package?
- Q&A: Options to Vent a Storage Compartment on an RV
- Q&A: Wiring Diagram for 7-Way Round Pin Trailer and Vehicle Side Connectors
- Q&A: Replacement Legs for Lippert Components Ground Control 3.0 Electric Leveling System
- Q&A: Roof Thickness Needed & How Far Does Handle Protrude Below Roof of MaxxFan Dome Plus Roof Vent
- Q&A: Recommended WeighSafe WDS for a 2021 Heartland Pioneer QB300
- Q&A: Is it Possible to Use Too High Rated of a Weight Distribution System
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Best RV Roof Vents
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Converting Your RV Water Heater to Tankless