How Long Is The LaSalle Bristol Cable-Actuated RV Waste Valve For Gray Water Tanks

Question

Question:

34466N11AB48GMA Can you let me know how long the valve body is?

asked by: Brian S

0

Expert Reply:

I went out to the warehouse and measured the LaSalle Bristol Cable-Actuated RV Waste Valve for Gray Water Tank # 34466N11AB48GMA and got the following measurements pictured below. If you were referring to a different part or need any other measurements just send in another question via our ask the experts link and I'd be happy to go back over and get you what you need.

expert reply by: Kevin C

0

34466N11AB48GMA Length
(click to enlarge)

Answer 1

Hi there Stephen! Since you're noticing the leak after dumping, the gate valve or its seals could definitely be the culprit. I'd lean toward replacing the entire valve assembly rather than just the O rings, especially if the valve body or…

view full answer...

Answer 2

We have just the replacement valve body for Lasalle Bristol RV waste valves with the part #34439241 but we don't have everything of the #34466N4AB120GM minus the spigot and hub.

view full answer...

Answer 3

Yes, the handle for the Bristol Waste Valve Body for RV Gray Water #34439241 is threaded onto the rod so it can be removed like what you're needing.

view full answer...

Answer 4

You should be able to tell which Valterra Double RV Waste Valves you need by inspecting your current connection points. The one end with the lugs on it is the same on all 3 parts so you simply need to determine if you need hubs, spigots, or a…

view full answer...

Answer 5

The LaSalle Bristol Cable-Actuated RV Waste Valve for Gray Water Tank #34466N11AB36GM is the best replacement for your 310115. This also fits a 1-1/2" pipe and has the same 36" cable length.

view full answer...

Answer 6

I don't know the length of the cable used for valves on your Montana so you'll want to measure the length to determine the correct replacement. To make the swap out easy I recommend just unbolting the old valve from the system and then swap…

view full answer...

Answer 7

I believe I understand what you are asking and while the handle of the Valterra Waste Valve Bodies w/ Flexible Cables for RV Black Water and Gray Water Tanks - 72" #TC1372 can be pointed down, and it is capable of a 90 degree angle, the cable…

view full answer...

Answer 8

This is a super common question so you're not alone in not knowing the difference in the connection types. A "SPIGOT" is a piece that will slide into another fitting such as the "HUB". If you look at the picture of the elbow…

view full answer...

Answer 9

If the sewer line you have is a 3 inch sewer line that slips into the both sides of the valve you have now the part #34466N4BB72GM will fit and work well. You will need to use ABS solvent like #3447530889 to install it as well. If instead one side…

view full answer...

Answer 10

Yes, you can swap out the LaSalle Bristol Cable-Actuated RV Waste Valve part #34466N4BB72GM that you have for the Valterra Waste Valve Body w/ Flexible Cable part #TC372. The swap will be a direct, bolt-on replacement as you can reuse the spigot…

view full answer...

Answer 11

Your valve is likely glued on with ABS cement already, which means you will need to go ahead and cut off your existing pipe line, and utilize ABS cement for a tight seal when installing the new waste valve you referred to: - LaSalle Bristol…

view full answer...

Answer 12

Typically it's not going to matter since the bolts are just used to hold the valve body together, so the bolts holding your current waste valve together won't matter. If you waned to use the LaSalle Bristol Cable-Actuated RV Waste Valve for…

view full answer...

How Long Is The LaSalle Bristol Cable-Actuated RV Waste Valve For Gray Water Tanks

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching