Is There a 2-5/16" Coupler That Can Be Used in Place Of a Shelby 5135 2" Ball Coupler?
Published 06/09/2023
Products Featured in This Question
Question:
I have a Shelby 5135 2” trailer coupler. I would like it to know if I can get it for a 2-5/16” ball. Thanks
asked by: Samuel
0
Expert Reply:
Instead of replacing your Shelby 5135 with the Coupler # CT-5003-Z which has the same design and 2" ball coupler you can replace it with the Demco 2-5/16" # DM13203-52. Both couplers fit a 3" wide trailer tongue. This coupler will require you to drill different mounting holes in your frame as they are not an exact match.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Channel Tongue Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Bolt On - 5,000 lbs
- Straight Tongue Trailer Coupler
- Standard Coupler
- 2 Inch Ball Coupler
- Bolt-On
- 5000 lbs GTW
- 3 Inch Channel
- Trigger Latch
- 2-Bolt
- Marine Grade
- etrailer
more information >
Continue Researching
- Q&A: Replacement For Shelby 5135 Coupler With 3 Channel
- Q&A: Replacement Cost Efficient Coupler for Shelby 5138
- Article: Trailer Lighting Requirements
- Article: Spring Towing Readiness Checklist
- Article: Trailer Wiring Diagrams
- Q&A: Wiring Instructions for the Tradesman Vaquero Hydraulic A-Frame Trailer Jack
- Q&A: Replacement for Swing Away Coupler/Actuator on MasterCraft Boat Trailer
- Article: Trailer Couplers
- Q&A: Availability of a Trailer Coupler that Fits a 3-1/2 Inch Wide Tongue
- Q&A: Can B and W Gooseneck Hitch Ball # BWGNXA2061 be Used with Andersen Ranch Hitch
- Q&A: Replacement Oil Seal for AL-KO 568303
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing