What Size Screws Are Included With The Valterra RV Sewer Hose Carrier
Updated 05/22/2023 | Published 05/19/2023
Question:
What size drill bit do I need for the 6 self tapping screws? The instructions do not provide that information. Thanks,
asked by: Jeff S
0
Expert Reply:
The screws included with the Valterra RV Sewer Hose Carrier # A04-5094BK are #14 x 1" self-tapping screws and would require either a 10mm or 3/8" socket in order to drive them into the trailer frame. Since these are self-tapping you would not need to drill out a hole first for the screw to bite through. If you wanted to go with a beefier screw you can pick up additional ones at your local hardware store.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Valterra RV Sewer Hose Carrier - Adjustable - 50" to 94" - Black
- RV Sewer Hose Support
- Hose Carrier
- Plastic
- 50 - 94 Inch Long
- Black
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Disc Brake Kit Recommendation for 2022 Grand Design Reflection 337RLS
- Q&A: How Wide Is MORryde Safe-T-Rail Wall Bracket
- Q&A: Weigh Safe True Tow Weight Distribution System For 7,600 Pound Trailer
- Q&A: Recommended Weigh Safe Weight Distribution System for a 7,600 lbs Travel Trailer
- Q&A: Wire Gauge for Installation of Progressive Dynamics 9300 Series Converter Charger on 2024 GD Imagine
- Q&A: Replacement Grease Seal for 5,100 Terran Axle
- Q&A: Does etrailer Carry Forever Lap Sealant
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure for Trailer Hitch Drop
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: RV Pre-Departure Checklist
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Wiring Diagrams