Weight of Thule RV Wheel Levelers

Question

Question:

Whats the weight of the pair of levelers?

asked by: Cal

0

Expert Reply:

The total weight is 8 lbs of the Thule RV Wheel Levelers # TH307617.

expert reply by: Kyle S

0

Answer 1

Hi C.J.; the bag for the 307617 Thule RV Wheel Levelers #TH307617 is 23" long x 6" tall x 8" wide.

view full answer...

Answer 2

You are correct! The FasTen RV Leveling Blocks w/ Carrying Handle #CAM44525 can be placed in any orientation that helps to level your trailer. The only thing you have to make sure of is that you don't go more than 4 blocks high as you aren't…

view full answer...

Answer 3

To protect the bottoms of your FasTen RV Leveling Blocks Item #CAM44525 and Item #CAM44512 when on gravel I recommend using outrigger pads like Item #337OP18X18R. These are a durable rubber pad so whether you are using them on concrete or asphalt…

view full answer...

Answer 4

What you'll do is use a separate wheel chock behind the wheels after using the Thule RV Wheel Levelers #TH307617. All you need to use is the Buyers Products 10" Wheel Chock #337WC1086UWH.

view full answer...

Answer 5

The instructions included with the Thule RV Wheel Levelers #TH307617 do state that the tires should be 20mm narrower than the width of the levelers for even support across the tires. That being said, these levelers are intended for motorhome use and…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Weight of Thule RV Wheel Levelers

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching