Replacement Round Tail Light For Kit Car With Obsolete 3-7/8" Diameter Tail Lights
Updated 04/11/2023 | Published 04/10/2023
Products Featured in This Question
Question:
need replacement for a LS328 red plastic lens from my classic kit car3 7/8 diameter, screw holes 3 in but about 1/2 off center.
asked by: Gerald A
0
Expert Reply:
It would appear those lights and lenses are obsolete. We do have the Peterson Tail Light # 432000 which has a similar design to your lights. This light is 3-3/4" in diameter, 2-5/8" thick and the mounting studs are 2" on center. If this lens were to break you can still get a Replacement Lens # 420-15.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Peterson Trailer Tail Light - 4 Function - Incandescent - Round - Red Lens - Driver Side
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- License Plate
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 3-3/4 Inch Diameter
- Red
- Peterson
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Replacement Axle and Hub for a Hooper Trailer
- Q&A: Are Driver and Passenger Side Peterson Trailer Tail Lights Different
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Options For Replacing A Tie Down Turbo Lube 48394 Clear Oil Bath Cap
- Q&A: 4 Inch Round Trailer Tail Light Cutout Size
- Q&A: Replacement Lens for Trailer Taillight SAE AP2 99 DOT
- Q&A: Adding a 7-Way Trailer Connector and Brake Controller to a 2014 Toyota Tacoma
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: How to Measure a Trailer Axle
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)