What Brake Assemblies Fit on the Dexter D80 Trailer Axle?
Published 03/23/2023
Products Featured in This Question
Question:
What brake assembly fits a Dexter D80 axle
asked by: Paul C
Expert Reply:
The Dexter Electric Trailer Brake Kit # 23-434-435 are the assemblies most often found on Dexter D80 axles which utilize electric brakes. If your axle is set up with hydraulic drum brakes they most likely have the Dexter Hydraulic Drum Brake Kit # 23-402-403. If you can locate the axle serial number I can reach out to Dexter to find out exactly what parts were installed from Dexter to verify the correct replacements and what upgrades are available. The serial number will be on the axle information sticker and is also stamped into the rear section of the axle tube near the passenger side.
Product Page this Question was Asked From
Dexter Nev-R-Adjust Electric Trailer Brakes - 12-1/4" - Left/Right Hand Assemblies - 8K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 12-1/4 x 3-3/8 Inch Drum
- 8000 lbs Axle
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- Dexter
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Looking For Drum Brakes That Fit An 8,000 Pound Axle
- Q&A: Replacement Grease Seals and Brake Magnets for a Dexter Electric Trailer Brake Assembly
- Q&A: Recommended Complete Flat Towing Setup for a 2023 Chevrolet Traverse W/ Lower Active Shutters
- Q&A: Is There Difference Between etrailer and Dexter 8k Trailer Brake Assembly Sets
- Q&A: Replacement Brake Pad Recommendation for Dexter 8,000 lb Axles
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Q&A: Replacement Brake Magnet and Spring for Dexter Electric Trailer Brake Kit (23-434/23-435)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Maintenance Schedule
- Article: Brake Controller Installation: Starting from Scratch
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer