How Long is the Top Part of the Tandem Axle Jeep Style Trailer Fenders

Question

Question:

The fenders are 72inch long at the bottom. Can you provide me with a measurement along the flat top portion of the fender?

asked by: Peter

0

Expert Reply:

I went out to our warehouse for you and measured the Tandem Axle Jeep Style Trailer Fenders part # HP62VR. The top part has a radius at each end so there isn't exactly a set point to measure from but I did my best to get the center of the radius and I found this to be around 54".

I have attached a photo below with this info.

expert reply by: Conner L

0

How Long is the Top Part of the Tandem Axle Jeep Style Trailer Fenders
(click to enlarge)

Answer 1

Sorry Jim but your wife already got to us and I'm afraid you'll have to go on the all-beet diet! I kid, I kid. The Rack'em shelf kit #RA-13 is great for shelves but to make some bunk beds I recommend going with E-Track #E19146. This…

view full answer...

Answer 2

According to B&W the B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit part #BWGNRK1020 is about a 2 hour install by a professional. All the Hardware is provided. I have attached the installation instructions so you…

view full answer...

Answer 3

Hi Cindy, Are you wanting to transition to electric drum brakes or would you just like to switch to an electric-over-hydraulic (EOH) setup that you'd be able to use a brake controller? If you want to switch to electric drum brakes you'll need…

view full answer...

Answer 4

Hubs and drums that can be turned (machined) will have a specification on how much they can be turned cast into the metal of the drum somewhere. Otherwise it is at the brake shop's discretion. Drums do not have to be turned unless there is some…

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

Hey Larry! If your DA66B is the drum brake model the Demco Hydraulic Brake Actuator #DM72VR is the direct replacement. Since you were asking about the Hydraulic Brake Kit #AKFBBRK-7-D as well I'll assume that is correct. The brake mounting…

view full answer...

Answer 7

Hey Morgan, the best hitch for what you are looking for would be the Draw Tite part #DT73RR which has the easiest install and the highest tongue weight rating. The hitch does fit right up under the rear bumper which will slightly reduce ground…

view full answer...

Answer 8

Hey Lawrence, thanks for reaching out. The Curt T-Connector #C56040 is correct for the 2025 Subaru Forester Hybrid. The factory harness plug should be in the rear cargo area behind the driver side access panel. If you remove the trunk floor covering…

view full answer...

Answer 9

Hey Nelson, welcome back and congrats on your new SUV! We get our information directly from Curt and their item #C13409 and item #C47HR hitches fit all models of the 2025 Subaru Forester including the hybrids. This is why we don't list a hybrid…

view full answer...

Answer 10

Hi Steven; I believe there was a change in the wiring for the 2026 model that doesn't allow the previous custom wiring to cross over. I'm sure Curt is working on a new wiring harness but we don't have an ETA on when that might be…

view full answer...

Answer 11

Hello Joshua, thanks for reaching out. Yes, we do have a trailer hitch for the 2025 Subaru Forester Hybrid. We actually have two hitch options for that, and it really comes down to your customers preferences. First is the etrailer Class 3 Hitch…

view full answer...

Answer 12

Running your own 12V power wire for the 7-Way on your 2021 Ford Explorer would give it the constant 12V power that the Curt Echo #C51180 needs, but I'm pretty sure we can remedy this problem without you having to splice into the wiring on your…

view full answer...

How Long is the Top Part of the Tandem Axle Jeep Style Trailer Fenders

Product Page this Question was Asked From

Continue Researching