What Sizde Fish Wire Is Needed To Install A Curt Trailer Hitch On A 2011 Ford Escape?
Updated 02/28/2023 | Published 02/26/2023
Products Featured in This Question
Question:
Hello, Im going to get your hitch 13650 and wiring harness 56329 for my 2011 ford escape. It appears I might need one of your fish wires. Which model number do I need?
asked by: Brannon
0
Expert Reply:
There is fish wire included with the Curt Trailer Hitch Receiver # 13650 for your 2011 Ford Escape, however if you need additional you'll just need the Curt Fish Wire Bolt Leader # C58400.
This fish wire will work with 1/2" bolts and measures 18" long. Attached are a couple of videos for you to check out as well.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Curt Fish Wire Bolt Leader - 1/2"
- Accessories and Parts
- 5th Wheel Hitch Rails
- Gooseneck Installation Kit
- Trailer Hitch
- Tools
- Bolt Leader
- 1/2 Inch
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Where Do I Plug In Curt T-Connector C56040 On A 2025 Subaru Forester Hybrid?
- Q&A: Recommended Base Plate Kit and Flat Tow Setup for a 2013 Jeep JK Wrangler
- Q&A: Ground Clearance for etrailer Class III Trailer Hitch e98904 On 2020 Chevy Equinox
- Q&A: How to Install a Weight Distribution System on a Straight Tongue Boat Trailer
- Q&A: Using Surge or Electric Brakes with A Weight Distribution Hitch
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Alarms and Locks to Prevent Theft From Enclosed Cargo Trailer
- Q&A: Does the Curt Trailer Hitch come W/ the Fish Wire for Install
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Hitch Installation Tips
- Article: Trailer Lighting Requirements
- Article: How to Measure for Trailer Hitch Drop