Bolster Brackets for Bunks on a Boat Trailer
Updated 01/23/2014 | Published 01/22/2014
Products Featured in This Question
Question:
the measurement from the bottom of the trailer frame to the bottom of the boat measures 12 inches. It appers the bolster with swivel bracket is 11 inches. Is this too short for what I need?
asked by: CJ
Expert Reply:
Considering that there will be a bunk of some kind mounting on top of the brackets once installed the 11 inch overall height of the CE Smith Bolster and Swivel Mounting Brackets # CE10001G-4 should work just fine for you.
If you determine the 11 inches is not enough we do have a set of four 13 inch brackets, # CE10002G-4. The slotted holes on these brackets will allow for some adjustability.
Product Page this Question was Asked From
CE Smith Bolster and Swivel Bracket Assemblies - Galvanized Steel - 11" - Qty 4
- Boat Trailer Parts
- Bunks
- Bunk Bracket
- Swivel Bracket
- 10 Inch Tall
- 2 Inch Tall
- 1-3/8 Inch Wide
- 2-1/2 Inch Wide
- Galvanized Steel
- 3-1/2 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Looking for 9" Wide Rollers and Brackets for a Holsclaw Boat Trailer
- Q&A: Can A 3" Bow Roller Be Replaced With a 4" Wide Roller?
- Q&A: Availability of 6' Long Roller Bunks
- Q&A: Should Keel Rollers Touch the Bottom of the Boat
- Q&A: Converting Boat Trailer From Rollers to Bunk Boards
- Q&A: Choosing a Replacement U-Bolt for a Boat Trailer
- Q&A: How Would Roller Bunks Install on Karavan Boat Trailer
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Tire Sizing
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Performance Chips and Modules
- Article: How Much Does a Boat and Trailer Weigh?
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements