Diameter Of The Bevel On The Global Link Thumb Turn Cam Latch
Updated 02/23/2023 | Published 02/22/2023
Question:
what is the outside diameter of the bevel face that contacts the rubber washer? My old Winnebago latches are a full 1 inch. Most of the inexpensive replacements are smaller. Hoping the stainless version is a bit larger. Thanks.
asked by: Michael Y
Helpful Expert Reply:
The OD of the Replacement Thumb Turn Cam Latch Cylinder # 295-000012 bevel is 7/8", which appears to be the standard for the latches we currently carry. You could slide a steel washer on first and then the rubber washer to help cover the gap.
Product Page this Question was Asked From
Replacement Thumb Turn Cam Latch Cylinder - Stainless Steel - 1-1/8" Long
- RV Door Locks
- Compartment Door
- Cam Locks
- Lock Core Only
- 1-1/8 Inch Long
- Silver
- Global Link
more information >
Continue Researching
- Q&A: How Much Space Is there Under the Cannister On the Pace Edwards UltraGroove Tonneau Cover
- Q&A: Correct Replacement Thumb Turn Cam Lock 1-1/8" Long x 3/4" Diameter
- Q&A: Should Air Lift WirelessONE Compressor Kick On When Truck Is Sitting With Everything Off?
- Q&A: DeeZee Red Label Truck Bed Tool Box For 2016 Ram 1500
- Q&A: Tool Box Compatible With REV Tonneau Cover
- Q&A: Canister Dimensions Of The Pace Edwards UltraGroove Retractable Hard Tonneau Cover # PE57CV
- Q&A: Pace Edwards UltraGroove Tonneaus that Fit 2024 Chevy Silverado 2500
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How Do Portable Generators Work? A Beginner's Guide to Powering Your Life
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)