Troubleshooting Nissan Truck Not Activating Trailer Stoplights and Blinkers
Published 02/15/2023
Question:
My trailer lights functioned as expected when connected to my Jeep. The same trailer only displayes tail lights with no brake or turn signals when connected to my Nissan pickup truck. Why is this? Single bulb vs dual bulbs?
asked by: Edmund G
0
Expert Reply:
Most likely it's dirty pins on your trailer wiring connectors. Specifically the ground circuit not being able to provide the amperage for the brighter illumination circuit of the brake and turn signals so try cleaning that. You should also check for blown fuses and relays under hood as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Standard Trailer Light Kit with 25' Wire Harness
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- License Plate
- Marker
- Square
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 5L x 4-1/2W Inch
- Amber
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Will The etrailer Hub AKIHUB-545-35-G-EZ-K Fit A 10 Inch Wheel?
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: Brake Assembly Needed For A Trailer With Timken 2788 And 1779 Bearings
- Q&A: 6k Hub Drum that Can Fit Timbren Axle Less Kit part # ASR1THDS03
- Q&A: Removing Trailer Bearing that is Stuck on Spindle After Removing Hub
- Q&A: Install Video For Standard Trailer Light Kit # TL29BK
- Article: How to Measure a Trailer Axle
- Q&A: Replacement 12 Inch Brake Assemblies for Redline EB01-140 and EB01-145 From Dexter Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Double-Eye Trailer Suspension System Review
- Article: Trailer Jacks
- Article: My Trailer Hitch Doesn't Fit