Replacement Amber LED 0277614 Clearance Light for 2021 Jayco Motorhome  

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

Hi Ray, the bolt hole spacing for the etrailer Electric Trailer Brakes #AKEBRK-35-SA is 2-7/8" on center, so these sound like they'll work perfect for you.

Hi Rusty; the Dexter #84546UC3-EZ and etrailer #AKHD-5475-35-K will both fit a 3,500 lb axle but they have different bolt patterns. You already ordered the Dexter in the past so I'm assuming your wheels are 5 on 4-1/2. For the same bolt pattern…

Hey Isaac! While we don't have one specific all in one kit we do have every component you will need to update your trailer's lighting and brakes. I recommend using the Trailer Wiring Kit item #ET7WK. This includes a 7-Way connector, a…

Your picture is a little blurry but from what I can see it looks like a clearance light that fits into a grommet that fits a hole in your RV. How they normally install is you put the grommet into the hole and then push the light in after from the…

It seems to me that your best bet would be to enlarge the hole slightly, and then push the wires back in once the connections are made. I would use a utility knife with a new blade to carefully enlarge the hole, being careful not to nick the wires.…

The fact that your existing hubs use bearings L68149 and L44649 indicates that the trailer has 84 spindles and the axles are more than likely 3,500 pound axles. The bearing numbers is how we identify things like the correct hubs and capacity so you…

Okay let's get started here with the suspension for your 2012 Skyline Koala 27CDS with 3,500 lb Axles; for the first part regarding your equalizers and suspension upgrade kit, so long as your current equalizer is spaced 6 inches (or close to it -…

The Chrome Trim Ring for Command Electronics Oval LED Clearance or Side Marker Light part #328-89-386 does just snap over the lens of the LED Trailer Clearance or Side Marker Light with Reflex Reflector part #328-K-52 or part #328-K-51. You are…

I can't speak for all trailer clearance and or marker lights but most like the LED Trailer Clearance or Side Marker Light with Reflex Reflector part #328-K-51 feature a simple two wire install, one for power and one for ground. If you aren't…