Replacement Bearings that Fit Malone MegaSport Trailer

Question

Question:

what size bearings for 2019 Malone mega sport?

asked by: Wayne R

0

Expert Reply:

All Malone trailers like the Malone MegaSport Trailer use a standard # L44643 bearing, so you can use the Bearing Kit for 1" BT8 Spindle, L44643 Inner/Outer Bearings, 34823 Seal # BK1-100 or just get the # L44643 bearings separately.

expert reply by: Jameson C

0

Answer 1

No, it is not normal for seals to go bad that quickly. Typically if your hubs are spraying/leaking grease, it is because of a bad seal. From what I could find, it looks like your Malone Microsport trailer has a 1.98 inch diameter hub. The correct…

view full answer...

Answer 2

The Sliding Storage Drawer for Malone MegaSport Kayak Trailer - 5.5 cu ft #MPG537 is made of molded plastic for durability and comes with stainless steel hardware, coated steel rollers, and sealed bearings. The overall dimensions are 48 inches long,…

view full answer...

Answer 3

Good morning Tim! The RV Designer Hitch Pin - 1/2" - Qty 1 #RD83GR measures a little over 3" from the clip hole to the edge of the straight part, just where it starts to bend. So that measurement is the span, and that tells us it'll…

view full answer...

Answer 4

The bearing part #L44649 has an inner diameter of 1.063 and is typically used in 3,500 lb axle hubs and the #L44643 has an inner diameter of 1 inch and is typically used on 2,000 lb axle hubs. If you can get me more info on your trailer like axle…

view full answer...

Answer 5

The 125255UC seal has a 1.249" ID and a 1.983" OD and for that our part #34823 will be the correct replacement.

view full answer...

Answer 6

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 7

Hey John, thanks for reaching out! Yes, you can replace your Dexter Electric Trailer Brakes #23-105-106 with the Dexter Electric Trailer Brakes #23-180-181. The only difference is going to be the strength of the magnet for the brakes.

view full answer...

Answer 8

Hey Jared! I recommend replacing your brakes over finding replacement shoes today then springs or magnets next time. I would need to know exactly what brake assemblies you currently have (part numbers) to look and see if we have replacement shoes and…

view full answer...

Answer 9

It is not required to install a washer between the outer bearing and the castle nut on the Trailer Idler Axle Beam with Easy Grease Spindles part #e48GR. That said, it's not a bad idea to use one and I recommend this to ensure there is no damage…

view full answer...