Does Replacement Clutchless Motor Head Work With Happijac 4200 Camper Jacks

Question

Question:

Will this replacement work with the 4200?

asked by: Marsha

0

Expert Reply:

I reached out to Happijac who said yes, your 4200 can use the replacement clutchless motor head, which is the following part number:

- Replacement Clutchless Motor Head for HappiJac Truck Camper Jacks # LC759927

They said this will work so long as your jacks use the Circuit Board # LC733513 with Remote Control # LC723915.

If you don't have the circuit board and remote, and your camper is already wired, you can get these with the Replacement Motor Heads w Circuit Board and Remote # LC733960. If it isn't prewired, you can get these all together with Manual-to-Electric Conversion Kit for HappiJac Truck Camper Jack Systems # LC733960-182524.

expert reply by: Kyle S

0

Answer 1

On the camper you'd have a set of the Happijac Z-brackets like part #LC182493 installed which is what the jacks like part #LC736514-4 attach to.

view full answer...

Answer 2

Your truck camper jacks are more than likely obsolete due to the age of your 1998 Big Foot truck camper. So unless they have been updated already you will need a new set of jacks. You can replace them with a HappiJac Electric Truck Camper Jack System…

view full answer...

Answer 3

We have 2 different remotes available for HappiJac electric camper jack systems. - Replacement Remote Control for HappiJac Electric Camper Jack Systems #LC723915 - Replacement Remote Controller for Wireless HappiJac Electric Truck Camper Jacks…

view full answer...

Answer 4

I took these steps from the instructions for the Replacement Remote Control for HappiJac Electric Camper Jack Systems item #LC723915. 1. To initialize the remote, press buttons 5 and 6 — the Down and Up buttons (Fig. 1) — at the same time. The status…

view full answer...

Answer 5

Having the replacement cable #LC149557 between the #LC723915 and the 723914 and then doing a reset is all that is required to sync the two. You must use the phone cord to connect the remote to the receiver either directly or through a remote plug in…

view full answer...

Answer 6

The Replacement Remote Control for HappiJac #LC723915 is the replacement remote compatible with the Replacement Circuit Board for HappiJac #LC733513. HappiJac has two remotes, one is compatible with the older circuit boards that have a 20 amp fuse.…

view full answer...

Answer 7

Since the motors work when connected directly to power and you are getting the green light on the remote, it sounds like everything is operational. The remote with the Replacement Circuit Board w/ Wireless Remote for HappiJac Electric Truck Camper…

view full answer...

Answer 8

It sounds like it may be the Circuit Board #LC733513 itself has gone bad. Your current circuit board is compatible with your Remote #LC723915. And I see you have the Remote Cable #LC149557 so it is safe to assume you have done all the proper…

view full answer...

Answer 9

I reached out to Happijac for clarification and I was told there are two different remote types. The remotes with the newer style logic boards have 25 amp fuses. Remotes with the old logic boards have 20 amp fuses. If you look at the rear of the…

view full answer...

Answer 10

The All Terrain Landing Gear part #TLA8000 is sold separately from the TorkLift GlowStep Camper Scissor Steps #TLA7802.

view full answer...

Answer 11

The HappiJac Electric Truck Camper Jack System #LC736514-ELKIT is the replacement kit for the 4100 series jacks that you have. It uses the same Replacement Jack #LC736514 and Motor Head #LC759927 for the front and rear jack positions.

view full answer...

Does Replacement Clutchless Motor Head Work With Happijac 4200 Camper Jacks

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching