How To Help Bras Stay On Better When Using Bearing Buddy Bearing Protectors - Model 1781
Updated 09/19/2022 | Published 09/17/2022
Products Featured in This Question
Question:
I have lost two Rubber Bra caps after just installing them on the bearing buddy on my boat trailer. Twice putting boat in the water, got home and the rubber Bra was gone. What do I do?
asked by: Paul L
0
Expert Reply:
If you're having trouble with the bras staying on the Bearing Buddy Bearing Protectors - Model 1781 part # BB1781 then you can wrap the exterior of the bearing protectors with electrical tape which adds thickness and should help the new Replacement Bearing Buddy Bras part # BB17B stay on better.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1781 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.78 Inch
- 3000 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Shop: Replacement Bearing Buddy Bras - Model 23B - (Pair)
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Q&A: How to Add Grease to Super Lube Trailer Hub with Rear Grease Zerk Fitting
- Q&A: Troubleshooting Weak Braking After Installing New Dexter Electric Brakes on Trailer
- Q&A: Trailer Hub Recommendation with 4 on 4 inch Bolt Pattern and Bearings L44643
- Q&A: Determining Which Diameter to Measure for Bearing Buddy
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Bearing Buddy that Fits Hub Bore Around 1.75 inch
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Lighting Requirements
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Replace an RV Roof Vent Cover
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Accurately Measure Trailer Leaf Springs