Base Pads For Scissor Style Stabilizer Jacks On a 2008 Fleetwood Mallard
Updated 09/19/2022 | Published 09/17/2022 >
Question:
The jack model #is J 5000 ,they are 9 inches in lenght and 4.5 inches wide. What snap pads will fit my 2008 mallard by fleetwood?
asked by: Charles T
0
Expert Reply:
I recommend using the Stromberg Carlson Base Pad Peak # SC58MR for the scissor jacks on your 2008 Fleetwood Mallard. Currently Snap Pad does not manufacture pads for your scissor jacks. The Stromberg pads are 8" tall reducing the amount of the jack that must be extended.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Stromberg Carlson Base Pad Peak for Scissor and Stabilizer Jacks - 3,500 lbs - Qty 4
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Leveling Blocks
- Plastic
- 3001 - 4000 lbs
- 12-3/8 Inch Lift
- 4 Jacks
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Step Covers for Suburban 3-Step Entry Steps
- Q&A: Availability of Side Crank Trailer Jack with Removable Handle
- Article: RV Pre-Departure Checklist
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Looking For Electric Jack That Can Be Rotated 90 Degrees
- Q&A: MaxxAir Vent Cover for Fan with 4 Mounting Tabs
- Q&A: Recommended LED Light Strip for 20' Awning
- Q&A: SumoSprings for 2025 Toyota Tundra 1794
- Q&A: What Is the Micron Rating of the AquaFresh Exterior RV Water Filter Kit
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)

