MaxxAir Vent Cover for Fan with 4 Mounting Tabs

Question

Question:

I have just installed a Maxxair 4000K fan that has the easy mount tabs on it for securing a Maxxair vent cover. It requires 4 of the easy clips to mount the vent cover to the fan but it appears the Maxxair II cover only has two of these clips for one side and some sort of hinge pins for the opposite side - is that correct? I need a cover with four 4 of the easy clips to install it on my 4000K fan. Can I still use the Maxxair II cover for my 4000K fan? see attached pic with hinge pins circled Thanks,

asked by: Darvin S

0

Expert Reply:

We actually have a few different version of the white rain covers from MaxxAir. The MaxxAir II # MA76JR that you referenced comes with the pins. This is for applications where the roof vent has the mounting tabs on one side.

Since you have the 4 mounting tabs on your MaxxAir 4000K you want the MaxxAir FanMate # MA00-955001 which comes with the 4 clips and the 4 brackets.

expert reply by: Jon G

0

click to enlarge

Answer 1

You would need the standard MaxxAir Vent Cover part #MA00-933069 as a vent cover for the top of your Ventline E-Z Lift Ventadome #V3094-603-00C.

view full answer...

Answer 2

The type of roof vent cover you need to attach to the vent cover brackets of your Maxxair 4951KS like part #MA00-04500K is the part #MA00-955003 which attaches to the brackets on the base of the vent with included cotter pins.

view full answer...

Answer 3

Yes you are correct the Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX is the right replacement and measures 18 1/8" long and 16 1/2" wide, which is the same measurements as your current MaxxFan Plus Roof Vent w/…

view full answer...

Answer 4

Actually the type of roof vent cover you need to attach to the vent cover brackets of your Maxxair 4951KS like part #MA00-04500K is the part #MA00-955003 which uses those brackets with the included cotter pins of the cover.

view full answer...

Answer 5

The MaxxAir II RV Roof Vent #MA76JR comes with all the needed hardware for installation. To install the cover you first need to position the cover in place and mark where the mounting brackets are located. Drill 3/16 inch holes in the marked…

view full answer...

Answer 6

Thank you for reaching out and providing all of the details! I have a solution for you to extend the Yakima OnRamp Bike Rack for 2 Electric Bikes Y36FR further out from your Arctic Fox 5th wheel RV but I think it's at least worth noting 2 things;…

view full answer...

Answer 7

To carry that much weight you'd need the Yakima EXO with two cargo boxes part #Y74ZR which has an 80 lb weight capacity for the top box and a 100 lb capacity for the bottom box. Then to give you the additional clearance past the rear of the…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

MaxxAir Vent Cover for Fan with 4 Mounting Tabs

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching