Solution to Improve Ground Circuit of Stromberg Carlson Electric Trailer Jack JET-3755
Updated 09/13/2022 | Published 09/11/2022
Question:
My jack is uses the grip washer to dig into the A-frame to make the ground connection. After a few rains, the washer evidently corrodes and loses connection and the jack wont work. Is there a way to use an actual wire to make the ground connection that will always work? my jack is the JET-3755 model thanks
asked by: Danny K
Expert Reply:
The best way to improve the ground of your A-Frame Trailer Jack part # JET-3755 is going to be run a jumper wire from the ground circuit of your trailer wiring connector to between the jack mounting flange and the trailer's a-frame.
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 24" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Q&A: Electric A-Frame Jack for 2019 Jayco SLX 212QB
- Q&A: Why Does My Stromberg Carlson Jack Keep Blowing the 30 Amp Fuse?
- Q&A: Looking for RV Door Hinge Assembly
- Q&A: Is There Replacement Screen for RV Screen Door?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Will Stromberg Carlson Jack # JET-3755 Replace Lippert Smart Jack Well
- Q&A: Looking For Dependable Electric A-Frame Jack With Drop Leg
- Q&A: Replacement A-Frame Jack for Lippert Ground Control TT
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: The Best Electric Trailer Jacks of 2025
- Article: Trailer Wiring Diagrams
- Article: Sidewinder with Rotating Turret for Short Bed Pickups