Thickness of the Trailer Weld-On Stake Pocket # HW03-080
Updated 10/31/2013 | Published 10/29/2013
Question:
how thick is the metal
asked by: James K
1
Helpful Expert Reply:
I went and pulled a Trailer Weld-on Stake Pocket # HW03-080 from our warehouse to measure the thickness of it and found it to be .23 inches. Check out the video I attached to see me measuring it.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Trailer Weld-on Stake Pocket - 6 Gauge
- Trailer Tie Down Anchors
- Stake Pockets
- Universal
- Steel
- Weld-On
- Fixed
- Surface Mount
- etrailer
more information >
Continue Researching
- Q&A: Brake Controller Wiring Harness on 2026 Ford F-250 WT
- Q&A: 12 Inch Long Equalizer For 2 Inch Slipper Springs & 8,000 lb U-Bolts For Tandem Axle Trailer
- Q&A: Comparing Lippert Never-Fail Bushings to the Bronze Bushings and Wet Bolt Option for Tandem Axles
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: Bolt Recommendations for a Equalizer for 2 inch Slipper Springs
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: Tool to Drive in 2.72" Hub Dust Caps
- Article: Trailer Maintenance Schedule
- Article: Trailer Lighting Requirements
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams