How to Remove Amber Lens on Marker Light and Bracket for Furrion Vision S RV Camera System

Published 06/23/2022

Question:

Im about to order this side lamp. Does the lens cover just pop off to access the installation screws? My RV is only a few months old and this light is out. I didnt want to break the one on the RV because the lens seems stuck on. It appears theres a rubber gasket seal that maybe I just need to pry harder.

asked by: Mark M

Helpful Expert Reply:

Yes, the lens cover on the Replacement Marker Light and Bracket for Furrion Vision S RV Camera System # FCE48TASL will just pop off, but you may need to use a flathead screwdriver to accomplish this. Wedge the end of the screwdriver into the small groove at the edge of the lens (see photo) and give a slight twist to free the lens and remove it.

Attached is an installation video of the whole Furrion Vision S system on a 2020 Grand Design for you to check out. If you jump to the 10:36 minute mark you'll see our installer pop off the lens as described above.

expert reply by: Jon G