What is the Diameter of the Fastener Holes on the Brophy D-Ring Light Duty Tie Down
Updated 10/16/2013 | Published 10/15/2013
Question:
What is the diameter of the 3 fastener holes?
asked by: Paul
Helpful Expert Reply:
The diameter of each fastener hole is 5/16 of an inch. The overall dimensions of this D-Ring are 3-1/2 inches by 5 inches. The center to center distance between the each fastener hole is 2 inches, and a total of 4 inches between the outermost holes.
To install this D-Ring, you will need a hole that is 3 inches in diameter, and recessed 5/16 of an inch, for a proper mounting location. I have included photos showing these dimensions for your reference.
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 3-9/16" Wide - Recessed Mount - 400 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 400 lbs
- Bolt-On
- Folding
- Recessed Mount
- Brophy
more information >
Continue Researching
- Q&A: Replacement Lippert Control Box for 140-1227 Box
- Q&A: Choosing D-Ring Cargo Tie Downs for Toy Hauler Trailer
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Q&A: Does Trailer Tire And Wheel Combos Need To Be Balanced?
- Q&A: Middle Jack Isn't Working on a Lippert 3.0 LC675817
- Q&A: How Do I Connect And Plug-In My Thomas Payne Seismic Loveseat Recliners?
- Q&A: Recommended Replacement for Atwood G6A-7 Water Heater
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Fifth Airborne Replacement Trailer King Pin with Air Cushions by Fifth Gear
- Article: Basics of Tie-Down Anchors