What Size Bolts are Used for the Handrail for Second Generation 4-Step MORryde Steps
Updated 05/10/2022 | Published 05/09/2022
Question:
What size thread and length are the four bolts?
asked by: Mike T
0
Expert Reply:
I contacted the manufacturer about the 4 bolts for the Handrail for Second Generation 4-Step MORryde Steps # MR73AR. They are 1/4" - 20 x 1 1/2” long – grade 5 zinc coated bolts. The washers are 1/4” grade 2 zinc coated.
expert reply by:
Scott S
0
Product Page this Question was Asked From
Handrail for Second Generation 4-Step MORryde Steps
- Accessories and Parts
- RV Steps
- Grab Handles and Handrails
- Fixed Handrail
- MORryde
more information >
Continue Researching
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: How to Determine What Generation of MORryde Steps You Have?
- Q&A: Are there Handrails for a MORryde Steps?
- Q&A: Replacement Bearing Solution for DICO Hub 45263
- Q&A: Will The MORryde RV Latch Extender Work With An RVLock Branded Entry Door Lock
- Q&A: Is B&B RV Water Center # BM72GR Only Available in Black
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: What is Best Plug and Play Flat Tow Lighting Kit for 2022 Jeep Wrangler Unlimited
- Q&A: Trailer Wheel Torque Spec Chart
- Article: How to Measure for Motorhome Steps
- Article: Trailer Lighting Requirements
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Raise Your Travel Trailer Height
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)