What Are the Overall Dimensions of the Optronics Under 80-Inch LED Trailer Light Kit # TLL9RK
Question:
What are the overall dimensions of the LandR lights,please?
asked by: David
Expert Reply:
The Optronics stud-mounted LED Trailer Light Kit, part # TLL9RK, features left- and right-hand LED light assemblies that are DOT-approved and waterproof, and includes a 25-foot wiring harness, mounting hardware and connectors, and a license plate bracket. The driver-side light includes license plate illumination.
These lights mount using two supplied steel studs (on 2-inch centers) and they use a 3-wire system for electrical connection to your trailer wiring. Each light has a white ground wire with ring terminal that is to be affixed to a clean unpainted metal surface; each also has a brown wire for running lights and either a yellow or green wire for stop/turn signals.
On the photo attached I have indicated several dimensions for the light assemblies.
Product Page this Question was Asked From
LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Reflector
- Stop/Turn/Tail
- Square
- Kit
- Surface Mount
- Submersible Lights
- LED Light
- 5L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Shop: LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Shop: Submersible, Under 80" Trailer Light Kit with 25' Wiring Harness
- Shop: CE Smith Trailer Idler Hub Assembly w/ Case for 2.5K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Q&A: Does Optronics Trailer Taillight Kits Use 4 or 5-Way
- Search Results: trailer light kit
- Search Results: tie down straps
- Search Results: trailer lights
- Search Results: trailer screws
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2 - Galvanized
- Shop: Double Lip Grease Seal - ID 1.249" / OD 1.983" - Qty 1
- Shop: Easy Grease Trailer Idler Hub Assembly for 2K Axles - 5 on 4-1/2 - Galvanized
- Article: How to Measure a Trailer Axle
- Video: Trailer Idler Hub Assembly for 2,000-lb Axles: The Breakdown
- Q&A: How Does the Submersible, Under 80" LED Trailer Light Kit part # TLL9RK Wire to Trailer
- Search Results: trailer lift
- Q&A: How to Pick Out Hub and Lighting for Harbor Freight Trailer
- Search Results: bearing grease
- Search Results: boat trailer lights
- Q&A: Tire and Wheel Combinations Balanced From The Factory
- Article: Trailer Wiring Diagrams
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Q&A: Would 7-Way Trailer Wiring Circuit Have Amperage Rating for Powering 13 amp Horn
- Q&A: Galvanized Hub With L44643 Bearings For 8 Inch Wheel
- Shop: Trailer Wiring
- Video: Complete Breakdown of the LED Combination Tail Light Kit for Trailers under 80" Wide
- Shop: Vehicle Seat Covers
- Shop: Windshield Wiper Blades
- Video: SeaSucker 4.5" Vacuum Mount with Stainless Steel Handle: The Breakdown
- Video: Trailer Connector Socket Installation - 2007 Chevrolet Silverado