Troubleshooting Connectivity Issues With The Furrion Vision S RV Camera System

Published 01/26/2023

Products Featured in This Question

Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen

(718)

$450.25

Replacement Antenna for Furrion Vision 1, 2, and S Wireless RV Camera Systems

(393)

$13.12

7-Way Vehicle Power Adapter for Furrion RV Observation Camera

(549)

$72.06

12V PWM Filter for RV Backup Camera Systems - Hardwire

(181)

$63.40

Question:

I bought harness and misplaced it but recently found it. Can you provide instructions on how to install?

asked by: Howard M

Expert Reply:

Since you're getting a signal issue while your Furrion Camera System # FOS43TASF monitor is closer to the camera it could be an issue with it not receiving enough power or that the antenna # 772577 on the camera or monitor is damaged and not properly sending the signal.

You can solve the lack of power issue by using the 7-Way Vehicle Power Adapter w/ Power Switch for Furrion RV Observation Camera # FR87PR, or my personal preference, installing the PWM Filter # VGR64VR. This filter splices in-line behind the camera for a permanent fix instead of having to haul around the Furrion adapter.

expert reply by: Kevin C

Howie

1/26/2023

I bought harness and misplaced it but recently found it. Can you provide instructions on how to install?

Kevin C.

1/26/2023

If you're referring to the PWM Filter # VGR64VR, the installation is super easy. You'll need to remove your shark fin mount from the trailer and pull out some of the wiring for your camera to have enough to splice in the filter. Once you have enough wire exposed you can cut it and splice in the filter using the attached butt connectors. I've attached a short video below where I'll walk you through the process.