How To Set Transfer Case Of 2022 Chevrolet Colorado In Neutral To Flat Tow and Parts Needed

Updated 04/25/2022 | Published 04/23/2022

Products Featured in This Question

Roadmaster Direct-Connect Base Plate Kit - Removable Arms

(3490)

$575.00

Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord

(3379)

$168.90

RoadMaster 68" Single Hook, Coiled Safety Cables - 6,000 lbs

(667)

$60.90

Roadmaster Battery Disconnect for Towed Vehicle w/ Flat Tow Brake System - Gas Only

(404)

$203.90

Question:

How do you no if truck has a 4x4 neutral transfer case I can’t find anything in manual and dealer is clueless . The switch on dash has high and low. Don’t see a N. For Neutral

asked by: Phil

Expert Reply:

For a 2022 Chevrolet Colorado you only flat tow four-wheel-drive vehicles that have an N (Neutral) and a Four-Wheel Drive Low (4 (n) setting. Look for knob on the dashboard. This will most likely be the last position on the right of the knob and be an "N" that will illuminate when placed in neutral.

First apply the parking brake and start the engine. Then shift the transfer case to N (Neutral). Verify that the vehicle is in N (Neutral) by shifting the transmission to R (Reverse) and then to D (Drive). There should be no movement. With the engine off, leave the key in ACC/ACCESSORY to prevent the steering column from locking.

For flat towing, you will need base plates, a tow bar and safety cables, a wiring solution for your indicator lights and a supplemental braking system.

- Base Plate, Roadmaster Direct-Connect Base Plate Kit, # RM37VR

- Tow Bar, Roadmaster Falcon All Terrain, Non-Binding Tow Bar, # RM-522

- Safety Cables, RoadMaster 68" Single Hook, Coiled Safety Cables, # RM-643

- Tow Bar Wiring, Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit, # RM-15267

- Supplemental Braking System, Brake Buddy Select 3 Portable Supplemental Braking System - Proportional # HM39524

Per the owner's manual, you will need to disconnect the negative battery cable to flat tow your vehicle. To this I suggest the Roadmaster Automatic Battery Disconnect with Switch for Towed Vehicle w/ Supplemental Braking System # RM-766.

You may or may not require a high/low adapter to keep your tow bar level. The objective is to have the tow bar set at +/- 3" of level once installed between the motorhome and vehicle under tow. This will require some measuring on your part so I've attached our help guide article to help you determine the correct rise/drop needed for your application.